描述

The NRG 40 anemometer is designed for the acquisition of wind speed.

Case Study 2

Norway

Case Study 6

Germany

Case Study 7

Egypt

我们如何帮助您

请填写以下的表格,我们将尽快回复您。



Category:

The NRG 40 anemometer is designed for the acquisition of wind speed.

NRG 40C

The 40C bearings and low moment of inertia permit very rapid response to gusts and lulls. A four-pole magnet induces a sine wave voltage into a coil, producing an output signal with frequency proportional to wind speed.

NRG 40H

The 40H is based on the NRG 40 C. This Hall Effect version is engineered for electrically noisy environments and instrumentation that requires a square wave signal.

The 40H’s Hall Effect switch produces a high-level square wave voltage signal with a frequency proportional to wind speed. This signal is easy to interface to a wide range of industrial devices including turbine controllers, programmable logic controllers (PLCs), and data loggers. A 5-26V DC excitation voltage with 5 mA of current is required.

Both of the anemometers are constructed of rugged Lexan cups, the 40H is molded in one piece for repeatable performance. A PVC terminal boot is included with each anemometer for additional protection from the elements.

The specifications below are from the NRG 40C

DESCRIPTION
Sensor type3 Cup Anemometer
ApplicationsWind resource assessment
Meteorological studies
Environmental monitoring
Sensor range1 m/s to 96 m/s
OUTPUT SIGNAL
Signal typeLow level AC sine wave, frequency linearly proportional to wind speed
Anemometer Transfer FunctionConsensus Transfer Function:
Scale Factor (Slope): 0.765 m/s/Hz
Offset: 0.35 m/s
Output voltage at threshold80 mV (peak-to-peak) minimum
Output voltage at 60Hz12 V (peak-to-peak) typical
Output amplitude NOT proportional to wind speed
Output amplitude NOT proportional to wind speed
Output signal range0 Hz to 125 Hz (at 96m/s, highest recorded)
RESPONSE CHARACTERISTICS
Distance constant (63% recovery)2.55 m at 5m/s per ASTM D 5096-02
2.56 m at 10m/s per ASTM D 5096-02
Swept diameter of rotor190 mm
INSTALLATION
MountingOnto a 13 mm diameter mast with cotter pin and set screw
Tools required0.25 inch nut driver, petroleum jelly, electrical tape
ENVIRONMENTAL
Operating temperature range-55 °C to 60 °C
Operating humidity range0 to 100% RH
PHYSICAL
Connections4-40 brass hex nut/post terminals
Weight0.14 kg
Dimensions3 cups of conical cross-section, 51 mm dia.
81 mm overall assembly height
MATERIALS
CupsOne piece injection-molded black polycarbonate
BodyHousing is black ABS plastic
ShaftBeryllium copper, fully hardened
BearingModified Teflon, self-lubricating
MagnetIndox 1, 25 mm diameter, 13 mm long, 4 poles
CoilSingle coil, bobbin wound, 4100 turns of #40 wire, shielded for ESD protection
BootProtective PVC sensor terminal boot included
TerminalsBrass

请求通话

填写表格,我们将尽快与您联系。

Enter your keyword